Datum/Zeit
Date(s) - 20/03/2026
09:00 - 16:30
Veranstaltungsort
Elster GmbH
Kategorien
Seminar aim:
Actuators and burner control units can be adapted for special use thanks to corresponding parameterization. Here, not only functional but also safety aspects must be taken into account. Honeywell Thermal Solutions burner control units BCU and actuators IC 40 can be programmed and set using the BCSoft software. This seminar provides information on the possibilities offered by this software and how to use it as well as practical exercises.
-
Inhalt:
- Theory
-
Normative and safety issues when programming the BCU
-
Introduction to the installation and use of BCSoft
-
BCSoft for the programming and visualizing of BCU 3xx, 4xx und 5xx, PFU,
FCU und IC40
Practice
-
Installation of the software, connecting and reading the devices
-
Programming exercises with BCU and IC40
-
Using BCSoft to help with troubleshooting and device replacement
Target group:
Trained personnel working for operators and companies commissioning industrial thermoprocessing equipment who have to install, check and replace burner control units BCU and actuators IC 40. This seminar builds on knowledge acquired during the practical seminar „Industrial gas utilization – Commissioning and maintenance“. We therefore recommend attending the practical seminar first to ensure you have the necessary basic knowledge.chpersonal bei Betreibern und Inbetriebnehmern von Industriellen Thermoprozessanlagen, die Gasfeuerungsautomaten BCU und IC40 installieren, prüfen und austauschen müssen.
Seminar organization:
Duration and times:
1 day, start : 09:00 am and finishing at 4:30 pm
Seminar venue:
Information center Elster Thermal Solutions, Strotheweg 1, 49504 Lotte – Germany
Refreshments:
Lunch and drinks are included in the course fee.
Travel and accommodation:
Travel and accommodation are not included in the course fee.
Seminar fee:
€ 720,00 per person plus VAT
